Weiss Enginering Ltd. DSP501/DSP502
2.4 Output Level
Be careful with the output level upon first opera-
tion. Best is to lower the level to a very low value
with the rotary knob or via the remote control.
The DSP50x has an additional level control to
match the basic output level with the amplifiers at
hand. Each output and each of its termination set-
tings can be set to different levels. Proceed as
follows:
Figure 7: Volume Trim menu section on the LCD
• Select the output you would like to set (1 or 2)
• Tap on the Setup pad on the touch screen
• With the knob scroll the display such that you can see the Volume Trim entry
• Tap on the Volume Trim pad in order to set the basic output level with the knob. 0dB is the highest level
while -30dB is the lowest level.
Now you may want to repeat that with the other output selected as the active output.
2.5 Selecting the output samplerate
The output sampling frequency can be set to any
of the following frequencies:
• 88.2 kHz
• 96 kHz
• 176.4 kHz
• 192 kHz
Figure 8: Selecting the Output Samplerate via the
LCD
Depending on the D/A Converter connected to the DSP50x output one may prefer one sampling frequency
over the other. Also some D/A converters may not be able to handle the high sampling frequencies (176.4 kHz
/ 192 kHz).
The first steps with your DSP50x 4 Quick Start Guide
To Next Page
Loading...
Need help?
General
