Weiss Enginering Ltd. DSP501/DSP502
Figure 4: The back panel of the DSP502
2.2 Output selection
The DSP50x has two digital outputs, XLR and RCA number 1 and XLR and RCA number 2. Only one of the
two outputs can be active at any time. The inactive one will be muted.
Select the active Output either with the remote control (two top/middle keys) or via the touch screen by pressing
on the red output icon to toggle between outputs 1 and 2.
This icon represents the currently active Output as well as its selected Output Termination (2.3).
Figure 5: Output 1 with Speakers Termination
Figure 6: Output 2 with Headphones Termination
Most of the parameters in the DSP50x can be set differently between outputs 1 and 2 (e.g. volume, volume
trim, equalizer settings etc.) and will be consistently saved when switching between outputs.
2.3 Output Termination
The DSP50x features multiple possibilities to finetune your setup, one of which is to accomodate either speaker
or headphone terminated setups. Therefor you may assign each output to its appropriate Output Termination:
• Speakers
• Headphones
Each output termination selection has its own set of exclusive plugins.
This is the default assignment is Speakers for both outputs, but may be changed at will using the Webinterface
or via the LCD display in menu section Setup > Output Termination.
Furthermore toggling of the Output Termination can be achieved by lengthily pressing (> 2s) the Output select
buttons on the remote control (2.7).
The first steps with your DSP50x 3 Quick Start Guide
To Next Page
Loading...
Need help?
General
