en
4 Installation and operating instructions • Wilo-Control EC-L • Ed.04/2022-09
1 General information
1.1 About these instructions
These instructions form part of the product. Compliance with the instructions is essential
for correct handling and use:
• Read the instructions carefully before all activities.
• Keep the instructions in an accessible place at all times.
• Observe all product specifications.
• Observe the markings on the product.
The language of the original operating instructions is German. All other languages of these
instructions are translations of the original operating instructions.
1.2 Copyright
WILO SE © 2022
The reproduction, distribution and utilization of this document as well as the communica-
tion of its contents to others without express authorization is prohibited. Offenders will be
held liable for the payment of damages. All rights reserved.
1.3 Subject to change
Wilo shall reserve the right to change the listed data without notice and shall not be liable
for technical inaccuracies and/or omissions. The illustrations used may differ from the ori-
ginal and are intended as an example representation of the device.
1.4 Exclusion from warranty and liabil-
ity
Wilo shall specifically not assume any warranty or liability in the following cases:
• Inadequate configuration due to inadequate or incorrect instructions by the operator or
the client
• Non-compliance with these instructions
• Improper use
• Incorrect storage or transport
• Incorrect installation or dismantling
• Insufficient maintenance
• Unauthorised repairs
• Inadequate construction site
• Chemical, electrical or electrochemical influences
• Wear
2 Safety
This chapter contains basic information for the individual phases
of the life cycle. Failure to observe this information carries the
following risks:
• Risk of personal injury from electrical, electromagnetic or
mechanical influences
• Environmental damage from discharge of hazardous sub-
stances
• Damage to property
• Failure of important functions
Failure to observe the information contained herein will result in
the loss of claims for damages.
The instructions and safety instructions in the other chapters
must also be observed!
2.1 Identification of safety
instructions
These installation and operating instructions set out safety in-
structions for preventing personal injury and damage to property,
which are displayed in different ways:
• Safety instructions relating to personal injury start with a signal
word and are preceded by a corresponding symbol.
To Next Page
Loading...
Need help?
General
