8
RECEIVER FUNCTIONS
FITTING & OPERATING INSTRUCTIONS
8-716-107-486d (12.06)
USER
INSTRUCTIONS
RECEIVER FUNCTIONS
1 NORMAL OPERATION:
LED (A) is continuously on when
there is a demand for heating and
continuously off when there is no
demand for heating.
Note: The LED is briefly interrupted
each time a signal is received.
2 SIGNAL RECEIVED:
LED (A) flashes twice each time a
signal is received from the transmitter.
3 LOW BATTERY STATE:
LED (A) flashes slowly, on for one
second and off for one second.
Replace the transmitter batteries as
shown under 'Battery Replacement'
and the receiver will revert back to
normal operation.
4 EMERGENCY MODE:
If a signal is not received for 60
minutes LED (A) continues to flash
rapidly and the CH is switched OFF.
Press button (B) and release for
manual override and to switch the
CH ON. Press again to switch the
CH OFF.
Once a signal is received from the
transmitter the receiver and heating
will revert back to normal operation.
1 sec
60 mins
8
1 sec
1
2
3
4
A
B
A
A
A
A
To Next Page
Loading...
Need help?
General
