4
FITTING THE RECEIVER
FITTING & OPERATING INSTRUCTIONS
8-716-107-486d (12.06)
DANGER - 24V & 230V:
DO NOT TOUCH THE
ELECTRICAL
COMPONENTS OR
CIRCUITS.
FITTING THE RECEIVER
CAUTION: ISOLATE THE MAINS
ELECTRICITY SUPPLY BEFORE
STARTING ANY WORK AND
OBSERVE ALL RELEVANT
SAFETY PRECAUTIONS.
!:-0/-.5-29;;<3
Remove boiler outer casing and
control panel fascia to gain access
to the heatronic control panel.
Release securing screw (A).
%
Pull cover panel (B) upwards to
remove.
&
Grip tab (C), pull upwards to
disengage clips (D) and pull
forwards to remove blanking plate
(E) or existing programmer.
'
Align connector pins (F) into
receptors (G) in the circuit board
and push fully home.
(
Feed the ribbon cable (G) into
recess (H).
)
Align programmer (E) and locate
clips (D), push into slots then
downwards to secure using grip tab
(C).
*
Locate cover panel (B) and secure
with screw (A).
Replace fascia cover and outer
casing before switching on the
electricity supply and boiler.
Switch boiler on when completed.
OBSERVE ELECTRONIC
STATIC DISCHARGE
PRECAUTIONS. DO NOT
TOUCH THE PCB CIRCUITS
INSTALLATION &
COMMISSIONING
6
E
C
5
1
A
B
D
E
C
2
3
F
E
4
H
G
A
B
D
7
To Next Page
Loading...
Need help?
General
