5
TRANSMITTER RADIO LINK
& SETUP LOCATION
FITTING & OPERATING INSTRUCTIONS
8-716-107-486d (12.06)
%
&
'
(
)
*
+
,
%
&
'
(
)
*
+
,
%
%
%
%
%
&
%
'
"
1.5m (5)
INSTALLATION &
COMMISSIONING
TRANSMITTER RADIO
LINK SETUP & LOCATION
Radio Link setup:
First remove the transmitter baseplate:
1
Locate a flat bladed screwdriver
into the slots in the baseplate (B), as
shown and twist to lift the transmitter
top (A) away from the baseplate (B).
Establishing a radio link:
2
Press and hold button (C) down
on the receiver for approximately 5
seconds to the enter setup mode
with the LED (D) continuously on.
The receiver is now ready to accept
a setup signal from the transmitter
for up to 2 minutes.
3
Fit the batteries (E) correctly into
the battery compartment (F) to enable
the transmitter to send a setup signal
to the receiver.
When a radio link has been established
the LED briefly flashes twice and
extinguishes. This link then remains in
the event of a power loss.
However, if a radio link has not been
established, remove the batteries from
the transmitter and wait 10 seconds
before repeating the setup procedure.
Transmitter Location:
4
Position the transmitter (A) as close
to the main living area as possible on
an inside wall, approx. 1.5m (5') above
the floor within the max. signal range
of the appliance receiver.
Keep the transmitter away from:
light and heat sources
enclosures and curtains
direct draughts, including fans, air
vents, windows and doors
damp and condensation.
1
A
B
2
3
A
C
E
D
4
F
A
To Next Page
Loading...
Need help?
General
