Making detailed settings
The following settings cannot be edited from the EASYCONTROL itself, so you’ll need to use the
EASYCONTROL software Editor. You can download the EASYCONTROL software Editor from
the website www.worlde.com.cn.
Global
Scene MIDI channel [1...16]
This specifies which MIDI channel the EASYCONTROL will use to transmit note messages, as
well as MIDI messages that are sent when you press the button or move the sliders and knobs.
This should be set to match the MIDI channel of the MIDI application that you’re controlling.
Transport MIDI Channel [1...16/Scene MIDI Channel]
Specifies the MIDI channel on which MIDI messages will be transmitted when you operate the
transport button. Set this to match the MIDI channel of the MIDI application you’re controlling. If
you set this to “Scene MIDI Channel,” the message will be transmitted on the Scene MIDI
Channel.
Group MIDI Channel [1...16/Scene MIDI Channel]
Specifies the MIDI channel on which each MIDI control group will transmit MIDI messages. Set
this to match the MIDI channel of the MIDI application you’re controlling. If you set this to “Scene
MIDI Channel,” messages will be transmitted on the Scene MIDI Channel.
Knobs
Operating a knob will transmit a control change message. You can enable/disable each knob,
specify its control change number, and specify the values transmitted when the knob is turned
fully left or fully right..
Knob Enable [Disable/Enable]
Enables or disables the knob. If you’ve disabled a knob, turning it will not transmit a MIDI
message.
CC Number [0...127]
Specifies the control change number of the control change message that is transmitted.
Left Value [0...127]
Specifies the value of the control change message transmitted when you turn the knob all the way
To Next Page
Loading...
Need help?
Power
Ports & interfaces
Weight and Dimensions