Worlde EASYCONTROL User Manual

to the left.
Right Value [0...127]
Specifies the value of the control change message transmitted when you turn the knob all the way
to the right.
Sliders
Operating a slider will transmit a control change message. You can enable/disable each slider,
specify its control change number, and specify the values transmitted when the slider is moved
fully upward or fully downward.
Slider Enable [Disable/Enable]
Enables or disables the slider. If you’ve disabled a slider, moving it will not transmit a MIDI
message.
CC Number [0...127]
Specifies the control change number of the control change message that is transmitted.
Upper Value [0...127]
Specifies the value of the control change message transmitted when you move the slider all the
way upward.
Lower Value [0...127]
Specifies the value of the control change message transmitted when you move the slider all the
way downward.
Assignable buttons
The button transmits a control change message. You can choose whether this button will be
enabled, the type of button operation, the control change number, and the values that will be
transmitted when the button is pressed. These MIDI messages are transmitted on the Global MIDI
Channel.
Assign Type [No Assign/Note/Control Change]
This specifies the type of message that will be assigned to the button. You can disable the button
(no assignment), or assign a note message or a control change.
Button Behavior [Momentary/Toggle]
Selects one of the following two modes:
Momentary: Pressing the button will send a control change message with the On value, releasing

Worlde EASYCONTROL Specifications

Power

power supply	USB bus power mode
current consumption	100 mA or less

Ports & interfaces

connectors	USB connector (mini B type)

Weight and Dimensions

width	13.4 inches / 340 mm
depth	3.9 inches / 100 mm
height	0.8 inches / 20 mm
weight	14 oz / 445 g