PPG DIGIMATCH SPECTROPHOTOMETER
11
3. Plug the USB connector into an available port on your computer.
NOTE: The device can also be connected directly using a USB-C
cable. Turn the device on and plug the round end of the USB-C
cable into the back of the device (1). Do not measure when the
device is connected.
4. Open the lid of the docking station. Insert the device in the docking
station with the USB-C connector facing down. Use the two pins as
a guide. The wrist band fits into the groove at the bottom of the
docking station.
5. The blue LED indicates the device is charging.
6. Once the device is charged, you can download your data using the
USB connection.
7. Plug the other end of the USB-C cable into an available port on your
computer.
8. Always store the device in the docking station when not in use to
protect it from dust and dirt.
Measure and Power On/Off Button
The button (1) is located on the side of the device. This is the same button that is used to power the device
on and off and to take measurements. You can also tap the screen (2) to initiate a measurement.
NOTE: Use this button to reset the device in case
it stops responding or locks up. Press and hold
the button for more than 10 seconds. Refer to the
Troubleshooting section for additional
information.
To reset the device, disconnect the USB-C
cable, press and hold the button for 3 seconds
and release. The device will turn off. You also
can use the power off icon in the settings menu.
(1)
(2)
(2)
To Next Page
Loading...
Need help?
General
