PPG DIGIMATCH SPECTROPHOTOMETER
14
SETTINGS MODE
Settings mode is used to adjust and view the device’s settings. You should review the current settings before
using the device for the first time. However, you can go back and change these settings at any time.
Entering Settings Mode
1. From the main screen, tap the icon to access the Settings screen.
2. Tap Measurement, Device, or System settings option. Once the Device and System settings screen is
opened, additional options can be viewed by swiping the screen up or down. Each option is explained
below.
Shut Down Device
This option is used to shut down the device.
To access, tap the icon at the top of the Settings screen and then tap Yes to confirm.
Measurement Settings
Automatic/Manual
This option is used to set auto measure mode.
Manual Measure: When set to Manual, you must press the Measure and On/Off button or tap the screen once
all three pressure sensor indicators turn green in the display to take a measurement.
Automatic Measure: When set to Automatic, this option allows the device to automatically take a measurement
once all three pressure sensor indicators turn green in the display. No button press or screen tap is required.
Once a measurement is taken, the device must be lifted up and repositioned to take another measurement.
To Next Page
Loading...
Need help?
General
