PPG DIGIMATCH SPECTROPHOTOMETER
9
INTRODUCTION AND SETUP
The multi-angle spectrophotometer is designed for consistent, precise color measurement of metallic,
pearlescent, and other complex special effect finishes.
This manual covers the installation, operation and maintenance of the device. Specific instructions for
using the device with your software application can be found in the software documentation.
Key features of the device are:
Color display with touch screen operation
Measure and power on/off button
Video targeting system for accurate positioning
Three pressure sensors located on the bottom of the device to aid in proper positioning
Wi-Fi technology (optional) for wireless communication
Packaging
Your device packaging should contain all the items listed below. If any of these items are missing or
damaged, contact X-Rite or your Authorized Representative.
PPG DigiMatch device
Calibration reference (white tile
and camera test target)
Docking station
USB-C interface cable
Quick start guide
Device Battery Pack
General
The battery pack for your new device comes in a low to medium charge state and should be charged
before use (up to 4 hours for full charge). Plug the USB connector into a standard USB charger or your
device docking station to charge the battery.
Battery Icon Information
This icon at the top of the screen would indicate the battery is fully charged.
Status LED
Measure and On/Off button
Touch screen
Measurement port
Pressure sensors (3)
USB-C input
Calibration Reference
To Next Page
Loading...
Need help?
General
