X-Rite DigiMatch PPG User Manual

PPG DIGIMATCH SPECTROPHOTOMETER
27
Replacing the Light Seal
1. Use your fingernail to lift one edge of the light seal (1) from the recessed area and remove.
2. Orientate the new light seal over the recessed area around the measurement port.
3. Press the new light seal into place until all rubber tabs are inserted properly and the light seal is lying flat.
Replacing the Battery Pack
The battery pack cannot be serviced or replaced by the user. Contact Technical Support if you experience
issues with the battery.
(1)

X-Rite DigiMatch PPG Specifications

General

Brand	X-Rite
Model	DigiMatch PPG
Category	Measuring Instruments
Language	English