Adjustments and Calibrations 6-19
The printer prompts the user to reset the life counts if the assembly is replaced after
receiving a Replace Transfer Roller or Replace Transfer Roller Soon message.
1. From the Main Menu, highlight Information and press OK.
2. Highlight Supplies Info and press OK
3. Highlight Reset Transfer Roller Life and press OK.
4. Reset Transfer Roller Life NOW is displayed, press OK to reset the Transfer
Roller life.
Service Diagnostics NVRAM Resets
PostScript NVRAM Reset
Resetting the printer setup values resets the job defaults, front panel language,
Intelligent Ready, Tray 1 (MPT), tray 2- 5 setup, Startup Page, front panel intensity,
front panel contrast, PostScript error information and E
NERGY STAR timeout to their
default values.
1. From the Main Menu, highlight Troubleshooting and press OK.
2. Highlight Service Tools and press OK.
3. Press the Up and Down buttons simultaneously to enter the Hidden Service
menu.
4. Highlight Run Service Diagnostics and press OK to enter Service Diagnostics.
5. Highlight NVRAM Access and press OK.
6. Highlight PostScript NVRAM Reset and press OK.
7. Select the specific entry desired (Yes or No) and press OK.
8. The printer now exits Service Diagnostics and reboots. While booting, NVRAM
is reset.
To Next Page
Need help?
General