Troubleshooting Precautions
CAUTION—SHOCK HAZARD: When you see this symbol on the product, there is a danger
from hazardous voltage in the area of the product where you are working. Unplug the product
before you begin, or use caution if the product must receive power in order to perform the task.
CAUTION—SHOCK HAZARD: This product uses an electronic power switch. It does not
physically disconnect the input AC voltage. To avoid the risk of electrical shock, always remove
the power cord from the printer when removal of the input AC voltage is required.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock while troubleshooting with
covers removed or doors open, do not touch the exposed wires or circuits while the printer is
connected to an electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock and to prevent damage to
the printer, remove the power cord from the electrical outlet and disconnect all connections to
any external devices before you connect or disconnect any cable, electronic board, or assembly.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury
from a hot component, allow the surface to cool before touching it.
CAUTION—PINCH HAZARD: To avoid the risk of a pinch injury, use caution in areas marked
with this label. Pinch injuries may occur around moving parts, such as gears, doors, trays, and
covers.
CAUTION—MOVING PARTS: To avoid the risk of laceration or abrasion injuries, keep hands
away from moving parts in areas marked with this label. Injuries from moving parts may occur
around gears and other rotating parts.
PPrrééccaauuttiioonnss DDee DDééppaannnnaaggee
ATTENTION ! RISQUE D’ÉLECTROCUTION : Ce symbole indique un danger lié à des niveaux
de tension dangereux dans la zone du produit à manipuler. Débranchez le produit avant de
commencer, ou agissez avec prudence si le produit doit être alimenté pour effectuer
l'opération.
ATTENTION ! RISQUE D’ÉLECTROCUTION : Ce produit utilise un commutateur
d'alimentation électronique. Il ne déconnecte pas physiquement la tension d'alimentation CA.
Pour éviter tout risque d'électrocution, débranchez toujours le cordon d'alimentation de
l'imprimante lorsque vous devez déconnecter la tension d'alimentation CA.
ATTENTION ! RISQUE D’ÉLECTROCUTION : Pour éviter tout risque d'électrocution lors du
dépannage de l'imprimante avec les capots retirés ou les portes ouvertes, prenez garde de ne
pas toucher les fils ou circuits dénudés si l'imprimante est connectée à une prise électrique.
ATTENTION ! RISQUE D’ÉLECTROCUTION : Pour éviter tout risque d'électrocution et éviter
d'endommager l'imprimante, débranchez le cordon d'alimentation de la prise électrique et
déconnectez toute connexion à tout périphérique externe avant de brancher ou débrancher des
câbles ou circuits et assemblages électroniques.
ATTENTION ! SURFACE CHAUDE : L'intérieur de l'imprimante risque d'être brûlant. pour
réduire le risque de brûlure, laissez la surface ou le composant refroidir avant d'y toucher.
34
Xerox
®
B310 Printer
Service Manual
Diagnostics and Troubleshooting