Storing and Handling Paper
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 Quick Reference Guide 89
When not in use, the paper trays can be opened and paper can be loaded while the
machine is running. However, do not open the active tray. This will cause the machine
to stop the job being processed.
Storing and Handling Paper
Always use high-quality, xerographic-grade paper in the machine. Damaged, curled, or
damp paper can cause jams and image quality problems. Follow these simple rules to
store paper.
• Store paper in dry conditions, away from extreme heat or cold, such as radiators or
open windows.
• Store paper flat on a shelf or pallet above floor level.
• Leave the paper wrapped and boxed until ready to be used.
• Re-wrap partly used packages of paper.
NOTE: Paper should not be stored in the paper trays.
Supported Paper Sizes and Types
This section lists the sizes and types of paper that can be used with the machine.
Supported Paper Sizes
The following table lists the paper sizes supported for each paper tray, duplex module
and the finisher.
NOTE: For the capacity of each tray, refer to the Specifications chapter on User
Guide.
Standard Sizes
NOTE: The standard sizes of paper that can be detected vary depending on the paper
size table specified by the Key Operator. For information on setting the paper size
table, refer to Paper Size Settings in the Setups chapter on User Guide.
Paper Size
Dimensions
(mm)
LEF/SEF
Tray 1, 2/Tray 3, 4
(Two Tray Module)
Tray 3, 4
(TTM)
Tray 5
(Bypass)
Duplex
Module
Finisher
A6 105.0 148.0 LEF X X O X X
A5 148.0 210.0 SEF O X O O X
LEF X X O O X
A4 210.0 297.0 SEF O X O O O
LEF O OOOO
A3 297.0 420.0 SEF O X O O O
To Next Page
Loading...
Need help?
General
