U
SING
P
RINT
M
ATERIALS
3.5
3
• For Card Stock or Custom-sized materials:
- Postcards, 3.5 by 5.83 in.(index) cards and other custom-
sized materials can be printed with this printer. The
minimum size is 76 by 127mm(3.0 by 5.0 in.) and the
maximum size is 216 by 356mm(8.5 by 14 in.)
- Always insert the short-edge into the Manual Feed first. If
you want to print in landscape mode, make this selection
through your software. Inserting paper long-edge first may
cause a paper jam.
- Do not print on media smaller than 76mm (3.0 in.) wide or
127mm(5.0 in.) long.
• For preprinted paper:
- Letterheads must be printed with heat-resistant ink that will
not melt, vaporize, or release hazardous emissions when
subjected to the printer’s fusing temperature of 205 °C
(400 °F) for 0.1 second.
- Ink on letterheads must be non-flammable and should not
adversely affect any printer rollers.
- Forms and letterheads should be sealed in a moisture-proof
wrapping to prevent changes during storage.
- Before you load preprinted paper as forms and letterheads,
verify that the ink on the paper is dry. During the fusing
process, wet ink can come off preprinted paper.
• Do not use
Carbonless
paper and
Tracing
paper. Use of
these types of paper could result in chemical smells and could
damage your printer.
To Next Page
Loading...
Need help?
General