Description of Menu Items
Phaser® 6280 Printer
97
Network Setup
Specifies printer settings affecting jobs sent to the printer through a network port.
• The settings in the Network Setup menu cannot be set when entering this menu during
printing.
• You need to restart the printer to activate the new settings. After making the settings,
turn off the printer and then turn it on again.
Item Description
Ethernet Specifies the communication speed and the modes of Ethernet.
• Auto (default)
Automatically changes between 10M Half Duplex, 10M Full Duplex, 100M
Half Duplex, and 100M Full Duplex.
•10M Base Half
• 10M Base Full
•100M Base Half
•100M Base Full
TCP/IP Specifies the settings to use the TCP/IP protocol.
Protocol Set Enable when using the protocol. When Disable is selected, the protocol cannot be
activated.
• LPR (default: Enable)
• Port 9100 (default: Enable)
• IPP (default: Enable)
• SMB TCP/IP
•SMB NetBEUI
• FTP (default: Enable)
• WSD (default: Enable)
• SNMP (default: Enable)
• Email Alerts (default: Enable)
• CentreWare IS (default: Enable)
• Bonjour (mDNS) (default: Enable)
IPP is displayed only when the optional multi protocol card is installed.
Host Access List Specifies blocking the reception of data from certain IP addresses.
Reset Defaults Initializes network data stored in NVM. The NVM is a nonvolatile memory that stores
the printer settings even after power off. Initializing the NVM will revert the value for
each item of the Wired Network menu to default.
Adobe Protocol Specifies the PostScript communication protocol: Standard, BCP, TBCP, Binary, or
Auto.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General