65 66
ENEN
FAQ
Problem Type Solution
Robot returns to the base without
performing auto-empty tasks
DND mode prevents the robot from performing auto-empty tasks.
The dust collection bag is full
Check whether the dust collection bag is full. If so, replace it with a new one. It is recommended to replace
the bag every 8-10 weeks. If not, check whether the dust intake or air duct at the bottom of the base is
blocked. Remove any blockage before use.
The auto-empty duration can be
unacceptably long sometimes
When the robot has been performing auto-empty tasks for a period of time, or when the air duct does not
function smoothly, the auto-empty duration will be extended to prevent blockage.
The upper cover of base fails to be closed Check whether a dust collection bag is installed. If not, install one.
Model RLS5D
Battery
5200mAh
(Battery Nominal Capacity)
Charging Time Approx. 6 hours
Wireless
Connectivity
Wi-Fi IEEE 802.11b/g/n 2.4 GHz
Rated Voltage 14.4 V
Rated Power 46 W
Operation
Frequency
2400-2483.5 MHz
Maximum
Output Power
＜ 20 dBm
Model RCS2
Rated Input 220-240 V~ 50-60 Hz
Rated Output 19.8 V
1 A
Rated Power 800 W
Specications
Robot Auto-Empty Base
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed
with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a
designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities.
Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the
installer or local authorities for more information about the location as well as terms and conditions of such collection points.
Undernormaluseofcondition,thisequipmentshouldbekeptaseparation
distanceofatleast20cmbetweentheantennaandthebodyoftheuser.
WEEE Information
To Previous Page
Loading...
Need help?
General
