Xilinx ML505 Getting Started Tutorial

ML505/ML506/ML507 Getting Started Tutorial www.xilinx.com 13
UG348 (v3.0.2) October 9, 2008
Board Setup
R
9. For Character delay, enter 20.
10. Click OK → OK to accept the settings.
11. Connect the DVI monitor or the VGA monitor with DVI-to-VGA adapter to the board,
if available.
12. Turn on the ML50x board’s main power switch and press the SYSACE RESET button.
After the FPGA has been programmed, the LEDs in the lower left corner should be:
♦ Bus Error 1 and 2 = off
♦ FPGA INIT = green
♦ FPGA DONE = green
♦ System ACE “Err” = off
♦ System ACE “Stat” = green
Note:
When the CF card is ejected or not installed, the System ACE “Err” LED blinks.
13. Extract the associated training lab files to your local computer. [Ref 3]
Unzip the training lab files to a working directory, name the directory, and make note
of the directory’s name. This directory with the extracted files is referred to as
<LAB_DIR> in this tutorial.
Figure 5: ASCII Setup
UG348_05_040408
www.BDTIC.com/XILINX

Xilinx ML505 Specifications

General

Brand	Xilinx
Model	ML505
Category	Motherboard
Language	English