24 FT-70DR/FT-70DE Operating Manual
Using the Memory
The FT-70DR/DE transceiver incorporates Large-capacity memory channels that can reg-
ister the operating frequency, communication mode, and other operational information.
• 900 Memory Channels
• 90 Skip Search Memory Channels
•
6 Home Channels
•
50 pairs PMS Memory Channels
Each memory channel can store the following information.
• Operating frequency • Communication mode • Frequency steps
• TX output power • Memory tag • Repeater information
• Tone information • DCS information • ATT information
• S
-
Meter squelch level • Skip memory information • Specified memory channel
information
Memory channels can be sorted and registered into memory banks according to the de-
sired use. The transceiver allows using 24 different memory banks. A maximum of 100
memory channels can be registered in each memory bank. One memory channel
can be registered to several memory banks. One memory channel in one memory bank
can be recalled, and the memory channels in the several memory banks can be scanned.
900
899
4
3
2
1
L50/U50
L49/U49
L4/U4
L3/U3
L2/U2
L1/U1
904
903
902
901
999
998
Memory Channel Configuration of the Transceiver
Memory channels
（
900 channels
）
Home channels
(6 channels)
Memorybanks
(24banks)
Up to 100 memory channels can be
registered to each bank.
(One memory channel can be registered
to several memory banks
）
Skip search memory channels
(99 channels)
PMS memory channels
(50 sets)
For additional details on the Skip Search Memory, PMS memory channel and Memory Bank,
refer to the Advanced Manual which may be downloaded from the Yaesu website.
CAUTIONS!
The information registered to memory channels can be corrupted by incorrect operation, static
electricity, or electrical noise. Also, it can be erased in the event of a failure or repair. Be sure to
keep a record of the settings on paper.
To Next Page
Loading...
Need help?
General
