Yaesu FT-712RH User Manual

Figure 6. Figure 7.
Memory Cloning
All memory data stored in one transceiver can be moved to another by connecting
the MIC jacks together as indicated in the diagram below (cloning cable is NOT
available from Yaesu).
(1) Turn both transceivers off, and then press and hold the F/WRITE buttons
while turning the power switches on. The displays will be blinking.
(2) Press the REV button on the destination transceiver (the display will stop
blinking).
(3) Press the RPT button on the source transceiver. When the data transfer is
complete, the displays should return to normal. If "Err" is displayed, turn
both transceivers off and try again.
(4) Turn both transceivers off and remove the cloning cable.
-16-

Yaesu FT-712RH Specifications

General

Brand	Yaesu
Model	FT-712RH
Category	Transceiver
Language	English