Yaesu FT-8900R User Manual

SCANNING
Yaesu FT-8900R Operating Manual Expanded Edition (courtesy of W5JCK) Page 42 of 77
Scanning
Overview
The FT−8900R allows you to scan just the Memory channels via Memory Scan Mode (see page
45), the entire operating band in VFO Scan Mode (see page 44), or a portion of that band via
Programmable Memory Scan (see page 23). It will pause on signals encountered, so you can
monitor the station(s) on that frequency.
Scanning operation is basically the same in each of the above modes. Before you begin, take a
moment to select the way in which you would like the FT−8900R to resume scanning after it
pauses on a signal.
Set the Scan-Resume Preference
Two options for the Scan-Resume mode are available:
TIME
In this mode, scanning will pause on a signal it encounters, and will hold there for five
seconds. If you do not take action to disable scanning within five seconds, scanning will
resume even if the stations are still active. This is the default setting.
BUSY
In this mode, scanning will pause on a signal it encounters. Two seconds after the carrier
has dropped, scanning will resume.
To set the Scan-Resume mode:
1. Press the SET key momentarily to enter the Set mode.
2. Rotate the DIAL knob to select Menu #34 SCAN.
3. Press the DIAL knob momentarily, then rotate the DIAL knob to select the
desired Scan-Resume mode (TIME or BUSY).
4. Press and hold in the DIAL knob for ½ second to save the new setting and exit to
normal operation.0.
Priority Channel Scanning (Dual Watch)
The FT−8900R’s scanning features include a two-channel scanning capability which allows
you to operate on a VFO, Memory channel, or Home channel, while periodically checking a
user-defined Priority Memory Channel for activity. If a station is received on the Priority
Memory Channel which is strong enough to open the Squelch, the scanning will pause on that

Yaesu FT-8900R Specifications

General

Brand	Yaesu
Model	FT-8900R
Category	Transceiver
Language	English