command a calibration action, or restore defaults, depending on the context when the *
key is pressed.
Enable Current Item Icon. When the * key is pressed, the current item displayed will
appear during the Operator Checklist sequence.
Deactivate Soft Key Icon. Indicates function is deactivated. Press the * key to
deactivate.
“Enable” Traction and Hydraulics for Forklift Icon. Press the 2 key to enable.
“Disable” Traction and Hydraulics for Forklift Icon. Press the 4 key to disable.
Hazard Flashers Icon. Press the # key to toggle the hazard flashers on and off.
Select system time for Fault Log event. Press the 1 key to select system time (this soft
key toggles between system times and hour meters).
Front Truck Lights Icon. Only available with CAN light controller. Press the 4 key to
turn truck lights on.
Rear Truck Lights Icon. Only available with CAN light controller. Press the 2 key to
turn truck lights off.
OVERLAY ICONS
Icons that look like they are placed over another icon are called overlay icons. This type of icon always
appears in conjunction with another icon, not by itself. Table 3 shows the overlay icons and describes how
they are used.
To Next Page
Loading...
Need help?
General
