Push down on press to
depress the tire beads until
the locking ring groove is fully
exposed.
8. Insert tire tool into the lock-
ing ring groove, and a vise
grip on other end. Remove
vise grip. Release the press
and check that all component
parts are correctly positioned.
Replace the valve core.
9. Inflate tire to 103 kPa (15 psi). Tap wheel with a mallet to
ensure all components are correctly sealed. Remove the
press from wheel and tire assembly.
Add Air to Pneumatic Tubeless Tire
WARNING
Add air pressure to the tires only in a safety cage. See
Figure 47. Inspect the safety cage for damage before
use. When air pressure is added, use a chuck that fas-
tens onto the valve stem. Make sure there is enough
hose to permit the operator to stand away from the
safety cage when air pressure is added to the tire. Do
not sit or stand by the safety cage.
Add air to tire to the recommended pressure that is shown
on the Nameplate. Install valve cap to ensure air stays in
the tire.
Maintenance
189
To Next Page
Loading...
Need help?
General
