98 Chapter 9—Aux Sends
01V—Owner’s Manual
Viewing Aux Send Settings
Settings for the aux sends can be viewed, and certain parameters adjusted on VIEW
pages 1 and 2.
1. Use the [AUX] buttons to select an aux send, and then press the MASTER
[SEL] button.
AUX appears on the display, indicating that an aux send is selected.
2. Use the [VIEW] button to locate VIEW pages 1 and 2, as shown below.
3. Use the cursor buttons to select the parameters, and the PARAMETER
wheel, [–1/DEC], [+1/INC], and [ENTER] buttons to set them.
Parameters are explained in the following sections.
To Next Page
Loading...
Need help?
General
