– 7 –
6. Air Funnel Set (MGC-021008-00)
Installation
1. Installing the Plate
Secure the plate onto the throttle body.
As shown, secure the plate only at two positions below, using the supplied screws (25mm
long).
2. Installing the Supports
Install the supports onto the levers.
Make sure to use the STD bush in the support hole.
*Use the lever and bushing intended for a STD machine.
Parts List
No. PART No. PART NAME Q’TY REMARKS
1 PLATE L 1
2 PLATE R 1
3 PRIMARY FUNNEL 4 L=55mm
4 SUPPORT L 1
5 SUPPORT R 1
6 SHAFT ASSY. 1 Short type
Support L
Lever Assembly
Support R
*Bush
*Bush*Lever
To Next Page
Loading...
Need help?
General
