Yamaha AR210 Owner's Manual

PRE-OPERATION
CHECKS
CHECK LIST
Before operating this boat, perform the
following checks:
If any item in the Pre-Operation
check is not working properly, have
it inspected and repaired before
operating the boat. Otherwise an
accident could occur.
3-4
3 OPERATION
ITEM CHECK
PAGE
REF.
BEFORE LAUNCH OR OPERATION:
STEERING Check for proper steering operation. 3-5
THROTTLE Check for proper throttle operation. 3-5
SHIFTING Check for proper shift operation. 3-5
LIGHTS AND HORN Check lights to be sure they operate. 3-90
Press horn button to be sure it operates. 3-10
FIRE EXTINGUISHER Check readiness of the extinguisher. 3-6
HULL Check the hull for damage or cracks
before launching.
ACCESS PORT CAPS Check for proper installation. 3-6
JET (WATER) Check that no debris is in the intakes 3-7
INTAKES before launching.
FUEL SYSTEM Check fuel system for leaks. 3-7, 4-10
FUEL AND ENGINE Check fuel and oil level; add as necessary. 3-7
OIL LEVELS
BATTERY Check battery condition, mounting, and connection. 3-7
DRAINAGE SYSTEM Check, and remove all water and fuel residue 3-7
before launching. Be sure drain plugs are tightened.
ENGINE Operate the blower for at least 4 minutes. 3-9
COMPARTMENT Open engine hood and check to be sure no
gasoline vapors are present.
ENGINE HOOD Check that hood latch is secure. 2-17
BIMINI TOP Check that the top is secure. 3-11
AFTER LAUNCH
SWITCHES Check operation of the ignition start switches 3-10
and engine stop switch lanyard.
COOLING WATER Check that water comes out while the 3-10
WARNING
NOTE: Steering and Shifting Pre-Operation Checks will require two persons, one person to operate
controls and one person to observe proper operation at the stern.

Yamaha AR210 Specifications

General

Length	21' 3"
Beam	8' 6"
Fuel Capacity	50 gallons
Storage Capacity	Multiple storage compartments
Seating Capacity	10 persons
Passenger Capacity	10 persons