Yamaha AR210 Owner's Manual

4-2
4) Turn off the water supply, then drain
residual water from the exhaust sys-
tem by alternately pushing the throt-
tle lever up to half throttle and back
for 10 to 15 seconds. Shut off
engine.
Never have the water on when the
engine is not running. The water
could flow back through the muffler
into the crankcase causing severe
engine damage. Do not run the engine
for more than 15 seconds after the
water supply has been turned off to
avoid engine overheating.
5) After stopping the engine, remove
the garden hose adapter.
6) Replace the cap securely.
7) Repeat the flushing procedure for
the other engine.
LUBRICATION
Do not spray flammable rust
inhibitor on engine surfaces while
the engines are hot. The sprayed
substance or propellants could
catch fire.
1) Open the hood (see page 2-17).
2) Lift the locking tab 1 on the air filter
case. Turn the air filter case cap 2
counterclockwise and then remove
the case cap.
3) Remove the air filter element 3.
4) Spray a rust inhibitor such as
Yamaha Stor-Rite Fogging Oil into
the intake opening 4 for 3 seconds.
5) Reinstall the air filter. Reinstall the
air filter case cap by lifting the tab
and turning the cap clockwise until it
stops.
6) Start the engine in a well-ventilated
area and let it run at a fast idle for 15
seconds.
Do not run the engine for more than
15 seconds. The engine could over-
heat.
4 MAINTENANCE & CARE
CAUTION:
WARNING
CAUTION:
1
2
3
4

Yamaha AR210 Specifications

General

Length	21' 3"
Beam	8' 6"
Fuel Capacity	50 gallons
Storage Capacity	Multiple storage compartments
Seating Capacity	10 persons
Passenger Capacity	10 persons