Yamaha F6B - Chapter 3 Operation; Operation

E
3
EMU00174
Chapter 3
OPERATION
INSTALLATION
..........................................3-1
Mounting the outboard motor ..................3-2
Clamping the outboard motor..................3-4
BREAKING IN (RUNNING IN) ENGINE
....3-5
PRE-OPERATION CHECKS
.....................3-6
Checking the engine oil level...................3-7
FILLING FUEL
............................................3-8
STARTING ENGINE
...................................3-9
Procedure for tiller control model...........3-10
Procedure for remote control model......3-13
WARMING UP ENGINE
...........................3-15
CHECKING POINTS AFTER
STARTING ENGINE
.................................3-15
SHIFTING
..................................................3-16
Forward ..................................................3-16
Reverse ..................................................3-17
STOPPING ENGINE
.................................3-18
TRIMMING OUTBOARD MOTOR
...........3-19
Adjusting trim angle................................3-20
TILTING UP/DOWN
..................................3-24
Procedure for tilting up...........................3-25
Procedure for tilting down......................3-25
Procedure for tilting up...........................3-26
Procedure for tilting down......................3-27
CRUISING IN SHALLOW WATER
..........3-28
Procedure...............................................3-29
Returning to original position .................3-29
CRUISING IN SHALLOW WATER
..........3-30
Procedure...............................................3-30
CRUISING IN OTHER CONDITIONS
......3-32
Cruising in salt water..............................3-32
Cruising in turbid water ..........................3-32
U68T14.book Page 1 Monday, April 1, 2002 4:32 PM