EasyManuals Logo

Yamaha MT 10 User Manual

Yamaha MT 10
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
Periodic maintenance and adjustment
8-26
1
2
3
4
5
6
7
8
9
10
11
12
EAU23026
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
ECA10584
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
[ECA11122]
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
may contain substances that
could damage the O-rings.
[ECA11112]
EAU23098
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
WARNING! Damage to the outer
housing of cables may result in in-
ternal rusting and cause interfer-
ence with cable movement. Replace
damaged cables as soon as possi-
ble to prevent unsafe condi-
tions.
[EWA10712]
Recommended lubricant:
Yamaha cable lubricant or other suit-
able cable lubricant
BW8-9-20_1.book 26 ペー 016年12月13日 火曜日 午前11時18

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha MT 10 and is the answer not in the manual?

Yamaha MT 10 Specifications

General IconGeneral
Engine TypeLiquid-cooled, 4-stroke, DOHC, 4-valve
Displacement998cc
Bore x Stroke79.0 mm x 50.9 mm
Compression Ratio12.0 : 1
Maximum Power118.0 kW (160.4 PS) @ 11, 500 rpm
Fuel SystemFuel Injection
Ignition SystemTCI
TransmissionConstant mesh, 6-speed
Final DriveChain
Front SuspensionTelescopic forks
Front Tyre120/70 ZR17 M/C (58W)
Rear Tyre190/55 ZR17 M/C (75W)
Overall Length2, 095 mm
Overall Width800 mm
Overall Height1, 110 mm
Seat Height825 mm
Wheelbase1, 405 mm
Minimum Ground Clearance135 mm
Wet Weight210 kg
Fuel Tank Capacity17 litres
Maximum Torque111 Nm (11.3 kg-m) @ 9, 000 rpm
Rear SuspensionSwingarm
Front BrakeDual hydraulic disc
Rear BrakeHydraulic disc
FrameAluminum Deltabox

Related product manuals