Yamaha MT-10SP User Manual

Special features
4-6
1
2
3
4
5
6
7
8
9
10
11
12
13
EAU97470
Cruise control system
This model is equipped with a cruise
control system designed to maintain a
set cruising speed without the need to
hold open the throttle by hand.
The cruise control system operates only
when riding in 4th, 5th or 6th gear at
speeds between approximately 50 km/h
(31 mi/h) and 164 km/h (101 mi/h).
WARNING
EWA21240
 Improper use of the cruise con-
trol system may result in loss of
control, which could lead to an
accident. Do not activate the
cruise control system in heavy
traffic, poor weather conditions,
or among winding, slippery,
hilly, rough or gravel roads.
 When traveling uphill or down-
hill, the cruise control system
may not be able to maintain the
set cruising speed.
 To prevent accidentally activat-
ing the cruise control system,
turn it off when not in use. Make
sure that the cruise control sys-
tem indicator light “ ” is off. Activating and setting the cruise
control system
1. Push the cruise control/YVSL
power switch “ ” located on the
left handlebar. The cruise control
system indicator light “ ” will
come on.
2. Push the “SET–” side of the cruise
control/YVSL setting switch to acti-
vate the cruise control system.
Your current traveling speed will
become the set cruising speed.
The cruise control setting indicator
light “ ” will come on.
Adjusting the set cruising speed
While the cruise control system is oper-
ating, push the “RES+” side of the
cruise control/YVSL setting switch to in-
crease the set cruising speed or the
“SET–” side to decrease the set speed.
TIP
Pushing the setting switch once will
change the set speed in increments of
approximately 1.0 km/h (1.0 mi/h).
Holding the setting switch will change
the set speed in increments of 5 km/h
(5 mi/h).
1. Cruise control setting indicator light “ ”
2. Cruise control system indicator light “ ”
1. Cruise control/YVSL setting switch
“RES+”
2. Cruise control/YVSL power switch “ ”
3. Cruise control/YVSL setting switch
“SET–”
Q
S
1000 r/mi
n
TRIP-1
MODE-
A
TRIP-2
12
RES
SET
MODE
PASS
1
2
3
BGG-28199-11.book 6 ページ ２０２２年８月２５日 木曜日 午後３時８分

Yamaha MT-10SP Specifications

General

Bore x Stroke	79.0 mm x 50.9 mm
Compression Ratio	12.0 : 1
Fuel System	Fuel Injection
Final Drive	Chain
Front Tire	120/70ZR17M/C (58W)
Rear Tire	190/55ZR17M/C (75W)
Transmission	6-speed
Front Brakes	Dual 320 mm hydraulic disc, ABS
Rear Brakes	220 mm hydraulic disc, ABS
Fuel Capacity	17.0 L
Engine Type	Liquid-cooled, 4-stroke, DOHC, 4-valve