Instrument and control functions
5-38
1
2
3
4
5
6
7
8
9
10
11
12
13
3. Turn the accessory off.
4. Insert the accessory plug into the
power outlet.
5. Turn the main switch on, and start
the engine. (See page 7-2.)
6. Turn the accessory on.
EWA21220
To prevent electrical shock or
short-circuiting, make sure that the
cap is installed when the power out-
let is not being used.
EAU15306
Sidestand
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See the following section for an expla-
nation of the ignition circuit cut-off sys-
tem.)
EWA10242
The vehicle must not be ridden with
the sidestand down, or if the sides-
tand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha’s ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
this system regularly and have a
Yamaha dealer repair it if it does not
function properly.
1. Power outlet
1
1
BGG-28199-11.book 38 ページ ２０２２年８月２５日 木曜日 午後３時８分
To Next Page
Loading...
Need help?
General
