Special features
4-9
1
2
3
4
5
6
7
8
9
10
11
12
13
To prevent accidentally activat-
ing the YVSL system, turn it off
when not in use. Make sure that
the YVSL display is off.
In some cases, the YVSL system may
not be able to maintain the set speed
limit when the vehicle is traveling down-
hill, under sudden acceleration, or im-
mediately following a gear shift.
If the vehicle exceeds the set
speed limit by 5 km/h (3 mi/h) or
more for more than 3 seconds, the
YVSL “ ” indicator icon will
flash until the vehicle speed de-
creases to within the limit.
If the vehicle traveling speed be-
comes higher than the set speed
limit, apply the brakes.
When the YVSL disengages, engine
output is gradually derestricted to en-
sure a smooth transition to full rider
control of the throttle.
Activating and setting the YVSL
1. Push the cruise control/YVSL
power switch “ ” located on the
left handlebar. The cruise control
system indicator light “ ” will
come on.
2. Push the cruise control/YVSL
power switch “ ” a second time to
switch to the YVSL standby mode.
The fuel meter (gear indicator in
track mode) will be replaced by the
YVSL display with the YVSL
“ ” indicator icon and a speed
setting indicator.
3. Push the “SET–” side of the cruise
control/YVSL setting switch to acti-
vate the YVSL. The YVSL “ ”
indicator icon will come on and the
speed limit will be set to your cur-
rent traveling speed which will be
shown on the YVSL speed setting
indicator.
1. YVSL display
2. Speed setting indicator
3. YVSL “ ” indicator icon
1
2
N
12
:
00
B
M
1
SCS
50
LIM
OFF
OFF
1. Cruise control/YVSL setting switch
“RES+”
2. Cruise control/YVSL power switch “ ”
3. Cruise control/YVSL setting switch
“SET–”
RES
SET
MODE
PASS
1
2
3
BGG-28199-11.book 9 ページ ２０２２年８月２５日 木曜日 午後３時８分
To Next Page
Loading...
Need help?
General
