To Next Page

To Previous Page

Operation

board and could distract the operator,

increasing the risk of collision with an-

other boat or an obstacle.

[EWM01851]

(3) To return the outboard motor to the nor-

mal running position, push the “ ”

(down) side of the power trim and tilt

switch to tilt the outboard motor down

slowly.

EMU41371

Operating in other conditions

Operating in salt water

After operating in saltwater, brackish water,

or water high in other minerals, flush the cool-

ing system with fresh water to minimize cor-

rosion and clogging of the cooling water

passages with deposits. Also, rinse the exte-

rior of the outboard motor with fresh water.

Operating in water containing mud, sand,

silt, debris, or vegetation

Mud, sand, silt, debris, and vegetation in the

water may restrict water flow into the cooling

water inlet covers or clog internal water pas-

sages. Check and clean the cooling water in-

let covers frequently when operating in these

conditions. Flush the engine with clean, fresh

water after use in these environments. Con-

sult your dealer if normal water flow can not

be restored by cleaning the cooling water in-

let covers or flushing with fresh water.

1. Power trim and tilt switch

U6FN36E0.book Page 62 Tuesday, November 30, 2021 8:08 AM

Yamaha VF115 User Manual

Questions and Answers: