Instruments and indicators
37
EMU36110
Start-up checks
Place the remote control lever in neutral and
turn the main switch to “” (on). After all the
displays come on and the total hour display
comes on, the gauge will change to normal
operation. If the buzzer sounds and the wa-
ter separator-alert indicator blinks, consult
your Yamaha dealer immediately.
IP:
To stop the buzzer, press the “” (set) or
“” (mode) button.
EMU36260
Oil level alert
When the oil level is low while cruising, the
oil level-alert indicator will start to blink. The
engine speed will automatically decrease to
about 2000 r/min.
When the buzzer sounds and the oil level-
alert indicator blinks, check the oil level and
add the oil if necessary. If the alert device
has activated while the appropriate engine
oil level is maintained, consult your Yamaha
dealer.
NOTICE
ECM01581
Do not continue to run the engine if the oil
level alert device has activated. Serious
engine damage will occur.
EMU36221
Overheat alert
If the engine temperature rises too high while
cruising, the overheat-alert indicator will start
to blink. The engine speed will automatically
decrease to about 2000 r/min.
1. Tachometer
2. Trim meter
3. Multifunction display
4. Water detection-alert indicator
5. Engine trouble alert/maintenance indicator
6. Cooling water pressure
7. Oil level (2-stroke models)
8. Cooling water/engine temperature
9. Battery voltage
1452
3
6978
ZMU05453 ZMU05419
ZMU05420
✩✫✳✬✤✲ ✦✪
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
