Operation
57
5. Immediately after the engine starts, re-
lease the main switch to return it to “”
(on).
NOTICE:
Never turn the main
switch to “” (start) while the en-
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 sec-
onds, the battery will be quickly dis-
charged, thus making it impossible to
start the engine. The starter can also
be damaged. If the engine will not
start after 5 seconds of cranking, re-
turn the main switch to “” (on), wait
10 seconds, then crank the engine
again.
[ECM00192]
EMU36510
Checks after starting engine
EMU36522
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
NOTICE
ECM01810
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
EMU27670
Warming up engine
EMU27704
Electric start and prime start models
After starting the engine, allow it to idle for 3
minutes to warm up. Failure to do so will
shorten engine life.
EMU36531
Checks after engine warm up
EMU36540
Shifting
While tightly moored, and without applying
throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
ON
START
OFF
ZMU01881
START
ON
ZMU04590
ZMU01882
✩✫✳✬✤✲ ✪
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
