Trouble Recovery
88
IP:
When you are maneuvering at low speed,
such as near a dock, it is recommended that
both engines be running with one in neutral
gear if possible.
EMU29493
Replacing fuse
If the fuse has blown on an electric start
model, open the fuse box and use a fuse
puller to replace the fuse with a spare one of
the proper amperage.
WARNING
EWM00631
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
NOTICE
ECM01382
●
If a main fuse has blown, be sure to also
check the other main fuse.
●
If the outboard motor is operated after a
main fuse has blown charging capabili-
ty will be insufficient, and the engine
will not start.
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29524
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit, the engine can be tilted
manually.
1. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Electrical cover
2. Fuse holder
3. Fuse (20 A
×
3, 30 A, 60 A
×
2)
4. Spare fuse (20 A, 30 A, 60 A)
5. Fuse puller
1. Fuse puller
2. Fuse (20 A
×
3, 30 A, 60 A
×
2)
4
5
2
3
4
3
1
ZMU04009
1
2
ZMU03562
✩✫✳✬✤✲ ✫✫
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
