Yealink DD10K User Manual

2
DD Phone Mode
Before using a IP phone as a DECT desk phone, you should
enable the DD phone mode first.
To enable the DD phone mode when the IP phone is
powered off:
1. Assemble the DD10K.
2. Power on the IP phone.
The DD phone mode is enabled automatically after the IP
phone is started up.
If you purchase the W41P package, the T41S DD phone
is registered to the W60B by default, so you can skip the
Registration process. If you purchase the DD10K package,
you should manually register the DD phone to one Base
station.
Registration
You can register up to 8 DD phones (for W60B) or 5 DD
phones (for W52P) to one base station. Each DD phone can
be registered to only one base station.
Before registering the DD phone, make sure the base station
is in registration mode (long press
on the base station till
the registration LED flashes).
To register the DD phone when the phone screen
prompts “Unregistered!”, do one of the following:
• Press the Reg soft key to register quickly.
• a. Do one of the following:
– Press the OK soft key, and then select Register
Handset.
–Press
, and then select Settings->Registration->
Register Handset.
The IP phone begins searching the base station.
b. Press the OK soft key after searching a base station
successfully.
Getting Started
E
N
G
L
I
S
H

Yealink DD10K Specifications

General

Wireless range	50 m
Frequency range	1880 - 1930 Hz
Brand compatibility	Yealink
Harmonized System (HS) code	85189000