Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
482
This section provides the sample configuration file necessary to configure the IP phone.
Any line beginning with a pound sign (#) is considered to be a comment, unless the # is
contained within double quotes. For Boolean fields, 0 = disabled, 1 = enabled.
This file contains sample configurations for the <y0000000000xx>.cfg or <MAC>.cfg file.
The parameters included here are examples only. Not all possible parameters are
shown in the sample configuration file. You can configure or comment the values as
required. The settings in the <y0000000000xx>.cfg file will be overridden by settings in
the <MAC>.cfg file.
Sample Configuration File
#!version:1.0.0.1
#Note: This file header cannot be edited or deleted.
#Network Settings
network.internet_port.type =
#Configure the WAN port type; 0-DHCP, 1-PPPoE, 2-Static IP Address.
#If the WAN port type is configured as DHCP, you do not need to set the
#following network parameters.
#If the WAN port type is configured as Static IP Address, configure the
#following parameters.
network.internet_port.ip =
network.internet_port.mask =
network.internet_port.gateway =
network.primary_dns=
network.secondary_dns =
#If the WAN port type is configured as PPPoE, configure the following
#parameters.
network.pppoe.user =
network.pppoe.password =
#Dial Plan Settings
dialplan.area_code.code =
dialplan.area_code.min_len =
dialplan.area_code.max_len =
dialplan.area_code.line_id =
dialplan.block_out.number.1 =
dialplan.block_out.line_id.1 =
dialplan.dialnow.rule.1 =
dialplan.dialnow.line_id.1 =
To Next Page
Loading...
Need help?
General