Getting Started
23
DHCP (Dynamic Host Configuration Protocol)
The phone attempts to contact a DHCP server in your network to obtain valid IPv4 network
settings (e.g., IP address, subnet mask, default gateway address and DNS address) by default.
Note
Phone Status
You can view phone status via phone user interface or web user interface.
Available information of phone status includes:
General information (IPv4 address or IPv6 address, MAC address and firmware version).
- IPv4 uses a 32-bit address.
- IPv6 is an updated version of the current Internet Protocol to meet the increased
demands for unique IP addresses, using a 128-bit address.
Network status (IPv4 status or IPv6 status, IP mode and MAC address).
Phone status (product name, hardware version, firmware version, product ID, MAC address
and device certificate status).
Account status (register status of SIP accounts).
To view the phone status via phone user interface:
1. Press , or tap ->Status.
2. Tap the desired item to view the specific information.
To view the phone status via web user interface:
1. Open a web browser on your computer.
2. Enter the IP address in the browser’s address bar, and then press the Enter key.
(e.g., “http://192.168.0.10” for IPv4 or “http://[2005:1:1:1:215:65ff:fe64:6e0a]” for IPv6).
If your network does not use DHCP, proceed to Basic Network Settings on page 24.