2.12 Connecting to a PC via USB (Installing
WTViewerFreePlus)
When you connect the WT310/WT310HC/WT330 to a PC, you can save measured data to the
PC and change the WT310/WT310HC/WT330 settings from the PC. In addition, you can use
WTViewerFreePlus, which is a software application supplied with the WT310/WT310HC/WT330, to
save measured data to the PC and change the WT310/WT310HC/WT330 settings, without having to
create original communication control programs.
WT310/WT310HC
WT330
PC monitor
Saved data
Setting changes
The WT310/WT310HC/WT330 can be connected to a PC using the following communication
interfaces.
• USB
• GP-IB
• RS-232
• Ethernet
This section explains how to connect the WT310/WT310HC/WT330 to a PC via USB.
To connect to a
PC via a different communication interface, see chapter 4 in the WTViewerFreePlus User’s Manual, IM
760121-02E.
Connecting the WT310/WT310HC/WT330 to a PC via USB
Use a USB cable to connect the USB port for PCs (type B connector) on the rear panel of the WT310/
WT310HC/WT330 to the PC.
USB port
USB port
WT310/WT310HC
WT330
PC
USB cable
To Next Page
Loading...
Need help?
General
