Zanussi ZITN646K User Manual

Problem Possible cause Remedy
comes on.
The Automatic Switch Off oper-
ates.
Deactivate the appliance and acti-
vate it again.
comes on
The Child Safety Device or the
Lock function operates.
Refer to the chapter “Daily Use”.
comes on
No cookware is on the cooking
zone.
Put cookware on the cooking
zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bottom of the
cookware is too small for the
cooking zone.
Move cookware to a smaller cook-
ing zone.
and a number come on
There is an error in the appliance. Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Con-
nect it again. If
comes on
again, speak to the service centre.
comes on
There is an error in the appliance,
because a cookware boils dry. The
protection against become too hot
for the cooking zone operates. The
Automatic Switch Off operates.
Deactivate the appliance. Remove
the hot cookware. After, approxi-
mately 30 seconds activate the
cooking zone again.
should
go out of the display, residual heat
indicator can stay. Let the cook-
ware become sufficiently cool and
check it with the section Cook-
ware for the induction cooking
zone.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ceram-
ic (it is in the corner of the glass surface) and an
error message that comes on.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instructions
about the customer service and conditions of
guarantee are in the guarantee booklet.
Installation
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
rating plate is on the bottom of the appliance
casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you as-
semble the appliance into correct built-in
units and work surfaces that align to the
standards.
Connection cable
• The appliance is supplied with the connection
cable.
10
www.zanussi.com

Zanussi ZITN646K Specifications

General

Boost function	Yes
Large cooking zone	2800 W
Number of boosters	2
Simmer cooking zone	1200 W
Regular cooking zone	1800 W
Number of power levels	15
Hob type	Zone induction hob
Product color	Black
Hob width size	59 cm
Top surface type	Ceramic
Appliance placement	Built-in
Cooking zone 1 type	Simmer
Cooking zone 2 type	Large
Cooking zone 3 type	Regular
Cooking zone 2 power	2200 W
Cooking zone 1 position	Left rear
Cooking zone 2 position	Left front
Cooking zone 3 position	Right rear
Cooking zone 4 position	Right front
Number of cooking zones	4 zone(s)
Simmer cooking zone shape	Round
Cooking zone 1 power source	Electric
Large cooking zone diameter	210 mm
Number of gas cooking zones	0 zone(s)
Simmer cooking zone diameter	145 mm
Regular cooking zone diameter	180 mm
Control type	Touch
Built-in display	-
Control position	Top right
Connected load (electric)	- W

Weight and Dimensions

Depth	520 mm
Width	590 mm
Height	- mm
Cord length	1.5 m
Installation compartment depth	490 mm
Installation compartment width	560 mm
Installation compartment height	50 mm