AEZZP0CB - MDI-CAN - User Manual Page - 5/13
1.2 Functional descriptions
1.2.1 LED function
The MDI-CAN has only a LED. This LED is red and lights and blinks when an
alarm is present.
1.2.2 Display function
Hour meter
An alpha-numeric liquid crystal display is fitted in the centre of the unit that shows
the Hours Worked. The display is backlight (the backlight is normally lighted).
Alarms
The same display can also indicate the Alarm state, showing a Code
corresponding to the type of Alarm. To attract attention, the Red LED will start
blinking when an Alarm is generated.
Software version
When the Key Switch is initially closed, the display shows the Eprom Version for
a few seconds (EPXXX where XXX represents the version): MDI-CAN and then
traction controller Eprom Version appears, each one for 2 seconds.
Simultaneously the symbol of a Monkey Wrench appears.
Battery State of charge
The battery's State of Charge indication is integrated in the LCD display; it is
shown by ten notches. Each notch represent the 10% of the battery charge. As
the battery becomes discharged, the notches turn off progressively, one after the
other, in proportion to the value of the residual battery charge. This value, sent to
the MDI-CAN by the controller via CAN-BUS, is displayed in the Tester Menu of
the Zapi Console connected to the controller. When BATTERY LOW alarm
appears on the controller, the battery symbol which is under the notches blinks.
Other information
Three symbols inform the operator as follows:
Turtle Symbol:
It is normally off; when it appears (fixed) it shows activation of the “soft” mode of
To Next Page
Loading...
Need help?
General