Zebra 105SL Quick Reference Guide

Load Ribbon
14
14023L-002 Rev. A 105SL Quick Reference Guide 6/20/07
Remove Used Ribbon
Remove used ribbon from the ribbon take-up spindle each time you change the roll of ribbon.
To remove used ribbon, complete these steps:
1. If the ribbon has not run out, cut or break it before the ribbon take-up spindle.
2. Push the hook until it slips out of the groove in the ribbon take-up spindle. Move the hook
back and forth to loosen the ribbon.
3. Remove the loosened hook from the ribbon take-up spindle.
4. Slide the used ribbon off of the ribbon take-up spindle and discard.

Zebra 105SL Specifications

General

Print technology	Direct thermal
Display	LCD
Product color	Gray
Network ready	Yes
Dimensions (WxDxH)	283 x 495 x 394 mm
Standard interfaces	Parallel, Serial
Internal memory	6 MB
Maximum label width	115 mm
Maximum label length	0.991 m
Power requirements	90-264 VAC, 48-63 Hz

Weight and Dimensions

Depth	495 mm
Width	283 mm
Height	394 mm
Weight	29000 g