Zephyr Pisa ZPI-E30BG User Manual

23
Pisa Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Maintenance
Removing Aluminum Mesh Filters
1. Push in filter latch.
2. Tilt filter down and remove from hood.
Replacing Aluminum Mesh Filters
Hood Model Part Number Quantity to Order
ZPI 50200054 1
To order parts, visit us online at http://store.zephyronline.com.
LumiLight LED
In the unlikely event that your LumiLight LED fails, please contact Zephyr to order replacement parts.
See the list of parts and accessories page for part numbers and contact information.
Push the clip
FIG. F
LED Removal (FIG. F):
1. Remove aluminum mesh filter.
2. Remove side panels if applicable, and remove
light panels by two screws.
3. Disconnect LED light quick connector.
4. Push in the two side clips on the ends of the
LED light.
5. Push LED light through the light panel opening.

Zephyr Pisa ZPI-E30BG Specifications

General

Color	stainless steel
Hood Type	under cabinet
Venting Type	convertible
Temperature Sensor	no
Number of Fan Speeds	3
CFM	500 cubic feet per minute
Filters	2
Sones	5.3 sones
Control Type	slide
Delay Start	no
Interior Light	yes
Remote Control	no
Voltage	120 volts

Weight and Dimensions

Depth	11 1/8 inches
Height	11 1/4 inches
Width	29 7/8 inches
Net Weight	33 pounds