20
PRW24F02CPG, PRB24F01BPG Use, Care, and Installation Guide
FULL SIZE COOLER
SINGLE & DUAL ZONE
PRESRV™
Installation Instructions
Carbon Filter
A built-in carbon filter protects your drinks by acting
as a natural barrier against harmful odors. The carbon
filter should be replaced every 3-6 months depending on
the unit’s exposure level to odor. If the unit is placed in a
kitchen, regular replacement every three months is ideal.
Remove the carbon filter by turning counterclockwise to
unlock from rear panel.
Carbon Filter Replacement Part #: Z0F-C004
Handle
Door Frame
Gasket
Flat Washer
Spring Washer
Screw
Installing a Zephyr Optional
Door Handle
Follow the instructions below to install a handle onto your
cooler. You may install your own handle onto the wood
overlay panel. Take care to measure and drill the handle
screw holes accurately and source the appropriate screws
(not included) unless using Zephyr accessory handles.
Refer to the images for Zephyr door handles.
1. Confirm if the overlay panel has already been installed
onto the unit. If not, refer to Installing the Overlay
Panel section to mount the overlay panel onto the unit.
2. Push aside the door gasket. Under the gasket you will
see two designated holes for handle installation. Mark
handle hole locations on the overlay panel.
3. Remove overlay panel from door. Using 3/16” drill bit,
create holes for handle screws.
4. Re-install overlay panel on the door.
5. Install the handle tightly as shown with (2) M4*55
screws, (2) M4 spring washers, and (2) M4 flat
washers.
NOTE: If using a custom handle, install the handle in the
position of your choosing with counter sunk screw
holes prior to installing the overlay panel to the
door.
Zephyr Presrv Pro Handle
Part #: PRHAN-F001 Color: Stainless Steel
Zephyr Presrv Contemporary Handle
Part #: 50280004 Color: Stainless Steel
To Next Page
Loading...
Need help?
General