Glossary JesterML Operating Manual
73-406-00 Issue 3.0 81 of 85
XLR
The connector range used for the DMX512-A input, DMX512-A output and Power
connectors on the back of the JesterML. There are various different XLR connectors
available, primarily:
• 3-pin (used for Audio and some DMX devices)
• 4-pin (used for power and colour scrollers). Note that you should never connect a
device with a 4 pin XLR to any other device unless they were built to be used
together. Different manufacturers use different voltages on these pins, and
misuse could result in damage to one or both devices.
• 5-pin (used for most DMX512-A devices).
Yellow
The colour of the PROGRAM/GO button when the desk is in PRESET mode.
Zero 88
The manufacturer of the JesterML.
To Next Page
Loading...
Need help?
General