94
HYDRAULIC EQUIPMENT
G419
G161
EXTERNAL CONTROL OF REQAR HYDRAULIC ARMS
External control of rear hydraulic arms can be found on the right rear mudguard and
allows to the operator easies connection of the implement, as movement of lower pull
roads of the three-point hitch can be controlled from outside of the tractor. It is only
used for connection and disconnection of farming mechanisms.
Fig. (A)
Before use of the external controls move the lever of regulation options (1) to position
P. Move the sliding stop of the internal hydraulic circuit lever (2) to the front limit posi-
tion.
Lowering of hydraulic arms, fig. (B):
Move the lever (3) in direction of the arrows (movement of the lever is restricted by a
rocker arm). Repeating of this procedure lowers the hydraulic arms in small steps.
Lifting of hydraulic arms, fig. (C):
Move the lever (3) in direction of the arrows (movement of the lever is restricted by a
rocker arm). Repeating of this procedure lifts the hydraulic arms in small steps.
During manipulation with the
three-point hitch using external
controls the operator shall stay
outside the area of the
mechanism attached as a
prevention to be caught or injured
by the mechanism.
To Next Page
Loading...
Need help?
General