7
III. INITIAL ASSEMBLY
In order to avoid shipping damage, the batteries and the seat unit are not separately packaged, so you
will need to assemble them onto the main frame of your scooter.
OPENING THE PACKING BOX
Open the packing box of your new scooter and remove all of the protective materials, then carefully
remove the scooter and separated components from the box.
ADJUSTING ANGLE OF TILLER (Figure 4.)
• Loosen the tiller adjustment knob located at the base of the tiller
• Lift the tiller up to a proper angle for yourself
• Tighten the tiller adjustment knob
ASSEMBLING THE SEAT POST (Figure 5.)
• Insert the chrome seat post into the seat post frame located on the rear section
• Align the adjustment pin hole
• Insert the adjustment pin into the aligned holes and out through the opposite side
To Next Page
Loading...
Need help?
General
