20 21
Click Apply to conrm your conguration.
APN Setting
Select Settings > 4G Settings > APN Setting, the APN parameters
are shown in the following gure:
• Prole Selection: Choose the desired prole name.
• Prole Name: Prole Name.
• APN: Access Point Name.
• PDP Type: Packet Data Protocol (PDP) Type IP is recommended
unless service provider instructs others.
• PDP Setting: PDP address mode. If a xed IP address is given
by your service provider, select Manual PDP. Otherwise select
the Auto PDP and the router will automatically obtain this
parameter.
• DNS: If a xed IP address is given by your service provider, then
choose Manual DNS. Otherwise, choose Auto DNS, and device
will automatically obtain parameters.
• Authentication: Password Authentication Protocol (PAP)
provides a simple method without encryption for the peer to
establish its identity using a 2-way handshake. Challenge-
Handshake Authentication Protocol (CHAP) is used to
periodically verify the identity of the peer using a 3-way
handshake.
• User Name: User name is used to obtain authentication from the
ISP when the connection is established
• Password: Password is used to obtain authentication from the
ISP when the connection is established.
Click Set default to set this prole as the default prole.
WAN Connection
In Cable Broadband mode
Click WAN Connection, you can congure how to connect to the
Internet.
Select WAN mode as Static, DHCP or PPPoE. If you select PPPoE
mode, you need to input the User Name and Password supplied by
the network provider, and select the Connect mode.
• Auto Connect: The router will automatically connect to WAN
when it is powered on.
• Manual Connect: Connect to the Internet or disconnect from the
Internet manually.
Click Apply to conrm your conguration, and then the gure will
show in the wan connection status.
In 4G Gateway mode
Click WAN Connection, you can congure how to connect to the
Internet.
MF29T User Manual V1.1-0703.indd 20-21 2012-7-3 16:46:30
To Next Page
Loading...
Need help?
General
